toyota

2022-2024 Toyota Tundra Engine Oil Change And Filter Replacement Instructions

By Viktor G · Certified Master Technician

Replace engine oil and filter on 2022-2026 Toyota Tundra models, including skid plate removal, active front spoiler procedure, and oil level check.

Skill Level: Beginner

As an Amazon Associate I earn from qualifying purchases. Product links below are affiliate links at no extra cost to you.

Parts Needed

→If equipped with active front spoiler, engage it before starting: ignition on, then off, then pull wipers UP (NOT towards you like shown in the video) and hold 2 seconds — do this within 45 seconds of shutting ignition off and don't turn ignition back on until oil change is complete.
→Warm up the engine before draining so oil flows faster and drains more completely.
→The front skid plate bolts at the front only need to be loosened, not fully removed — slide the plate out.
→Use a length of 5/8 inch hose on the oil filter housing nipple to direct draining oil into a container and avoid making a mess on the subframe.
→Always install a new drain plug gasket and make sure the old one is fully removed to avoid double-gasketing, which can cause leaks.
→The new oil filter seal comes pre-lubricated — no need to apply additional oil.
→Tighten the oil filter by hand only; using the filter wrench to tighten makes it very difficult to remove next time.
→Apply anti-seize to skid plate bolts before reinstalling.
→After filling with oil, run the engine a couple of minutes, then let it sit before checking the dipstick so oil drains back into the pan.
→Apply a small amount of oil to the dipstick O-ring to prevent it from getting stuck.